Results 1 to 3 of 3
  1. #1
    Peter is offline Got in 1st drag race
    Joined
    Feb 2001
    From
    NJ
    Posts
    34

    Default

    Hello,

    Does anyone know the best way to add another cooling line off the pump??? Or should i just "t" the water inlet off to other parts of the head and the exhaust manifold(coffman's pipe). WHere is a good spot to tap into my stock head to add other cooling lines on each cylinder....thanks Peter

  2. #2
    scott25a is offline Getting the hang of it
    Joined
    Feb 2001
    From
    New Jersey
    Posts
    20

    Default

    Peter, I don't know about adding a second cooling line from the pump. I figure it could be done, but it probably is not necessary to do. (that would be a good question for Tim)I run the stock setup with an inline water strainer. I do however run a waterline off the rear cylinder out the side of the boat. The rear cylinder tends to run hot (compared to the front and middle)on the 1995 900's.
    I am running an ADA head, they are already setup to accept cooling lines for all 3 cylinders. I have never experimented with the stock head. Sorry I cannot help there.

    Scott

  3. #3
    scott25a is offline Getting the hang of it
    Joined
    Feb 2001
    From
    New Jersey
    Posts
    20

    Default

    Peter, I looked at a spare pump for my 900 the other night. There are two spots on the pump for waterlines. So, if you wanted to run dual lines you would have to remove the pump and drill/tap a hole for a fitting. Then you would have to drill a hole in your ski to get the water line into the engine compartment. That is about as far as I can help, as I said before I only run one line.

    Scott

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 900 ZXI and 1100 ZXI engine
    By Dickeyray in forum Kawasaki
    Replies: 5
    Last Post: 05-01-2007, 02:27 PM
  2. 95 zxi 900 installed primer wont stay running
    By chase73 in forum Kawasaki
    Replies: 1
    Last Post: 07-18-2006, 06:09 PM
  3. exit cooling line
    By julio gaspar in forum Sea-Doo
    Replies: 7
    Last Post: 12-13-2005, 11:56 AM
  4. 1996 900 zxi
    By Halter in forum Kawasaki
    Replies: 4
    Last Post: 07-15-2005, 12:50 AM
  5. kawasaki zxi 1100 pulse line fittings
    By xcsnowman in forum Kawasaki
    Replies: 6
    Last Post: 06-27-2005, 12:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •