Sea-Doo 4-TEC Codes

[pwcskier]

Re: Sea-Doo 4-TEC Codes

What is fault code P0500? It is not listed. I have the local dealer trying to find out.

[Technical Support]

Re: Sea-Doo 4-TEC Codes

Only prior to 2003.

[Colin]

Re: Sea-Doo 4-TEC Codes

Is it possible to remove the Maintenance warning without using B.U.D.S?

[Technical Support]

Re: Sea-Doo 4-TEC Codes

No, and there are no glitch codes.

[Fuzzy2133]

Re: Sea-Doo 4-TEC Codes

no, I was just curious if no power to the computer would clear the memory, so you could see if the code is real or a glitch.

[Technical Support]

Re: Sea-Doo 4-TEC Codes

Some codes need to be cleared by the dealer, it depends on the fault and repair. Do you have one showing?

[Fuzzy2133]

Re: Sea-Doo 4-TEC Codes

is there a way to clear the codes? can disconnecting the battery work?

[Technical Support]

Re: Sea-Doo 4-TEC Codes

Even with the troubleshooting info, pretty much every fix requires the dealer anyway.

[Dick]

Re: Sea-Doo 4-TEC Codes

You can check to see if you have any codes by putting the tether cap on, pushing the SET button 5 times and it should display them. Then use the mode switch to scroll thru the list, at the end of the list pushing the mode switch will end that function.
When using BUDS it will give a detailed procedure for troubleshooting the code.

[RXP26]

Re: Sea-Doo 4-TEC Codes

wow thats a huge help .. i was wondering where i could find that info for my rxp

[Technical Support]

Here is the list of trouble codes displayed on all Sea-Doo 4-stroke 4-TEC equiped skis. It will take a dealer and parts to cure most of these, but it at least gives you an indication of the fault, and sometimes you can replace the part yourself.

P0106
Manifold atmospheric presure sensor out of range

P0107
Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to ground

P0108
Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to 12V or open circuit

P0111
Intake manifold temp sensor faulty

P0112
Intake manifold shorted to ground

P0113
Intake manifold shorted to 12V or open circuit

P0116
Engine temp sensor faulty

P0117
Engine temp sensor shorted to ground

P0118
Engine temp sensor shorted to 12V or open circuit

P0122
TPS out of range - short to ground

P0123
TPS out of range - short to 12V or open circuit

P01231
Fuel pump shorted to ground or open circuit

P0232
Fuel pump shorted to 12V

P0261
#1 injector short to ground or open circuit

P0262
#1 injector shorted to 12V

P0264
#2 injector short to ground or open circuit

P0265
#2 injector shorted to 12V

P0267
#3 injector short to ground or open circuit

P0268
#3 injector shorted to 12V

P0236
Knock sensor out of range

P0336
Crank position sensor - wrong RPM detected

P0337
No CPS signal, but CAPS signal detected

P0339
Crank signal fault not plausible with cam signal

P0344
Cam phase sensor signal missing

P0351
Ignition coil #1 open circuit or shorted to ground or to 12V

P0352
Ignition coil #2 open circuit or shorted to ground or to 12V


P0353
Ignition coil #3 open circuit or shorted to ground or to 12V

P0461
Fuel level sensor circuit out of range

P0462
Fuel level sensor shorted to ground

P0463
Fuel level sensor circuit shorted to 12V or open circuit

P0505
DLA output stage cutoff memory cuircut or output stage fault or open circuit or short to 12V

P0513
Incorrect DESS key

P0520
Oil pressure switch faulty

P0544
Exhaust gas temperature sensor fautly

P0545
Exhaust gas temperature switch shorted to ground

P0546
Exhaust gas temperature switch shorted to 12V or open circuit

P0562
Battery voltage too low

P0536
Battery voltage too high

P0600
CAN communication problem detected by EMS or MPEM

P0601
TPS learns unlikely or checksum fault

P0602
ECU not coded

P0604
RAM faulty

P0605
EEPROM faulty

P0605
Checksum fault EEPROM

P0608
Sensor 5V power supply short to ground

P0608
Sensor 5V power supply short to 12V

P0616
Starter relay short to ground or open circuit

P0617
Starter relay short to 12V

P1102
TPS adaption failure

P1104
TPS adaption cancelled

P1148
Fuel injector 1,2 or 3 - safety fuel cutoff disabled

P1200
Blow-by valve shorted to ground or open circuit

P1201
Blow-by valve shorted to 12V

P1202
Oil tank pressure switch implausible or blow-by valve still closed

P1517
Compass out of range

P1590
VTS position sensor out of range

P1591
VTS position sensor - low voltage

P1592
VTS position sensor - high voltage

P1593
VTS malfunction

P1607
MPEM fault

P1675
Spare output 1 shorted to ground or open circuit

P1676
Spare output 1 shorted to 12V

P1678
Spare output 2 shorted to ground or open circuit

P1679
Spare output 2 shorted to 12V

P1680
Comminication problem detected by MPEM

P1681
Communication problem - instrument cluster message missing

P1682
Communication problem - EMS message missing

P1683
COM RAM fault

P1690
VTS control up circuit open circuit or shorted to ground

P1691
VTS control up circuit shorted to battery

P1692
VTS control down circuit open circuit or shorted to ground

P1693
VTS control down circuit shorted to battery

P0344, P1200
Burnt TOPS 10A fuse

P1675
Burnt depth gauge or spare 2A fuse

P0353, P0267
Burnt cylinder #3 ignition coil and injection 10A fuse

P0352, P0264
Burnt cylinder #2 ignition coil and injection 10A fuse

P0351, P0261
Burnt cylinder #1 ignition coil and injection 10A fuse

P1680, P1681
Burnt information center 1A fuse

P0616
Burnt Bilge pump, beeper, diagnostic center 3A fuse

P1678
Burnt spare 5A fuse

P0231
Burnt starter, fuel pump 10A fuse

P0600
Burnt MPEM 2A fuse

P1690, P1692

Burnt VTS 7.5A fuse