Announcement

Collapse
No announcement yet.

Impeller installation?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Impeller installation?

    Well my new impeller and wear ring came in, but not the service manual. I know how all the parts go back together except, do I have to seal anything with silicone other than the screws that fasten the ride plate to the hull? I assume the pump shaft is sealed already? When I took the old impeeler off there was some silicone on the base where it seats on the shaft. Also the new impeller came with what seems to be a ceramic or very hard rubber spacer which makes it the same length as the old one. does this stay on it? the new impeller is stainless and the old one is aluminum. Thanks again Randy

  • #2
    I believe the spacer should stay, and the only place I think you need silicone is where the pump meets the hull.

    Comment

    Working...
    X