Announcement

Collapse
No announcement yet.

MFD Quit after jumper mod

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • MFD Quit after jumper mod

    Hey guys found the post on the jumper mod for th '00 virage. Did that this a.m. and it starts fine, but now the MFD went out. To recap what I did, I went into the electrical box and unpluged the red/purple wire at the bullet connector it had 2 wires going into one right before the connector. I then connected them to an all orange wire. Hooked everything back up and it started fine. I have unplugged the MFD for few minutes but that did'nt fix it. Any suggestions?

  • #2
    Re: MFD Quit after jumper mod

    You must have unplugged the power cable to the MFD. OR the little fuse that goes to the power cable on the MFD blew. Happened to me. Open the box back up and try to trace the problem using a multimeter and some small jumper wires.

    Comment

    Working...
    X