Announcement

Collapse
No announcement yet.

Sea-Doo 4-TEC Codes

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Sea-Doo 4-TEC Codes

    Here is the list of trouble codes displayed on all Sea-Doo 4-stroke 4-TEC equiped skis. It will take a dealer and parts to cure most of these, but it at least gives you an indication of the fault, and sometimes you can replace the part yourself.

    P0106
    Manifold atmospheric presure sensor out of range

    P0107
    Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to ground

    P0108
    Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to 12V or open circuit

    P0111
    Intake manifold temp sensor faulty

    P0112
    Intake manifold shorted to ground

    P0113
    Intake manifold shorted to 12V or open circuit

    P0116
    Engine temp sensor faulty

    P0117
    Engine temp sensor shorted to ground

    P0118
    Engine temp sensor shorted to 12V or open circuit

    P0122
    TPS out of range - short to ground

    P0123
    TPS out of range - short to 12V or open circuit

    P01231
    Fuel pump shorted to ground or open circuit

    P0232
    Fuel pump shorted to 12V

    P0261
    #1 injector short to ground or open circuit

    P0262
    #1 injector shorted to 12V

    P0264
    #2 injector short to ground or open circuit

    P0265
    #2 injector shorted to 12V

    P0267
    #3 injector short to ground or open circuit

    P0268
    #3 injector shorted to 12V

    P0236
    Knock sensor out of range

    P0336
    Crank position sensor - wrong RPM detected

    P0337
    No CPS signal, but CAPS signal detected

    P0339
    Crank signal fault not plausible with cam signal

    P0344
    Cam phase sensor signal missing

    P0351
    Ignition coil #1 open circuit or shorted to ground or to 12V

    P0352
    Ignition coil #2 open circuit or shorted to ground or to 12V


    P0353
    Ignition coil #3 open circuit or shorted to ground or to 12V

    P0461
    Fuel level sensor circuit out of range

    P0462
    Fuel level sensor shorted to ground

    P0463
    Fuel level sensor circuit shorted to 12V or open circuit

    P0505
    DLA output stage cutoff memory cuircut or output stage fault or open circuit or short to 12V

    P0513
    Incorrect DESS key

    P0520
    Oil pressure switch faulty

    P0544
    Exhaust gas temperature sensor fautly

    P0545
    Exhaust gas temperature switch shorted to ground

    P0546
    Exhaust gas temperature switch shorted to 12V or open circuit

    P0562
    Battery voltage too low

    P0536
    Battery voltage too high

    P0600
    CAN communication problem detected by EMS or MPEM

    P0601
    TPS learns unlikely or checksum fault

    P0602
    ECU not coded

    P0604
    RAM faulty

    P0605
    EEPROM faulty

    P0605
    Checksum fault EEPROM

    P0608
    Sensor 5V power supply short to ground

    P0608
    Sensor 5V power supply short to 12V

    P0616
    Starter relay short to ground or open circuit

    P0617
    Starter relay short to 12V

    P1102
    TPS adaption failure

    P1104
    TPS adaption cancelled

    P1148
    Fuel injector 1,2 or 3 - safety fuel cutoff disabled

    P1200
    Blow-by valve shorted to ground or open circuit

    P1201
    Blow-by valve shorted to 12V

    P1202
    Oil tank pressure switch implausible or blow-by valve still closed

    P1517
    Compass out of range

    P1590
    VTS position sensor out of range

    P1591
    VTS position sensor - low voltage

    P1592
    VTS position sensor - high voltage

    P1593
    VTS malfunction

    P1607
    MPEM fault

    P1675
    Spare output 1 shorted to ground or open circuit

    P1676
    Spare output 1 shorted to 12V

    P1678
    Spare output 2 shorted to ground or open circuit

    P1679
    Spare output 2 shorted to 12V

    P1680
    Comminication problem detected by MPEM

    P1681
    Communication problem - instrument cluster message missing

    P1682
    Communication problem - EMS message missing

    P1683
    COM RAM fault

    P1690
    VTS control up circuit open circuit or shorted to ground

    P1691
    VTS control up circuit shorted to battery

    P1692
    VTS control down circuit open circuit or shorted to ground

    P1693
    VTS control down circuit shorted to battery

    P0344, P1200
    Burnt TOPS 10A fuse

    P1675
    Burnt depth gauge or spare 2A fuse

    P0353, P0267
    Burnt cylinder #3 ignition coil and injection 10A fuse

    P0352, P0264
    Burnt cylinder #2 ignition coil and injection 10A fuse

    P0351, P0261
    Burnt cylinder #1 ignition coil and injection 10A fuse

    P1680, P1681
    Burnt information center 1A fuse

    P0616
    Burnt Bilge pump, beeper, diagnostic center 3A fuse

    P1678
    Burnt spare 5A fuse

    P0231
    Burnt starter, fuel pump 10A fuse

    P0600
    Burnt MPEM 2A fuse

    P1690, P1692

    Burnt VTS 7.5A fuse
    SBT Tech Support is here to help with your problems.
    We try to answer each question quickly and accurately.
    Please do not use Private Messaging for Tech Support, use the forums.

  • #2
    Re: Sea-Doo 4-TEC Codes

    wow thats a huge help .. i was wondering where i could find that info for my rxp
    #*@* ME IF IM WRONG ... BUT HAVENT WE MET BEFORE?

    Comment


    • #3
      Re: Sea-Doo 4-TEC Codes

      You can check to see if you have any codes by putting the tether cap on, pushing the SET button 5 times and it should display them. Then use the mode switch to scroll thru the list, at the end of the list pushing the mode switch will end that function.
      When using BUDS it will give a detailed procedure for troubleshooting the code.
      Dick Bell
      http://www.hansenskidoo.com

      Comment


      • #4
        Re: Sea-Doo 4-TEC Codes

        Even with the troubleshooting info, pretty much every fix requires the dealer anyway.
        SBT Tech Support is here to help with your problems.
        We try to answer each question quickly and accurately.
        Please do not use Private Messaging for Tech Support, use the forums.

        Comment


        • #5
          Re: Sea-Doo 4-TEC Codes

          is there a way to clear the codes? can disconnecting the battery work?

          Comment


          • #6
            Re: Sea-Doo 4-TEC Codes

            Some codes need to be cleared by the dealer, it depends on the fault and repair. Do you have one showing?
            SBT Tech Support is here to help with your problems.
            We try to answer each question quickly and accurately.
            Please do not use Private Messaging for Tech Support, use the forums.

            Comment


            • #7
              Re: Sea-Doo 4-TEC Codes

              no, I was just curious if no power to the computer would clear the memory, so you could see if the code is real or a glitch.

              Comment


              • #8
                Re: Sea-Doo 4-TEC Codes

                No, and there are no glitch codes.
                SBT Tech Support is here to help with your problems.
                We try to answer each question quickly and accurately.
                Please do not use Private Messaging for Tech Support, use the forums.

                Comment


                • #9
                  Re: Sea-Doo 4-TEC Codes

                  Is it possible to remove the Maintenance warning without using B.U.D.S?
                  Colin

                  Comment


                  • #10
                    Re: Sea-Doo 4-TEC Codes

                    Only prior to 2003.
                    SBT Tech Support is here to help with your problems.
                    We try to answer each question quickly and accurately.
                    Please do not use Private Messaging for Tech Support, use the forums.

                    Comment


                    • #11
                      Re: Sea-Doo 4-TEC Codes

                      What is fault code P0500? It is not listed. I have the local dealer trying to find out.
                      David B. Thomas<br />Blew-By-You PWC Services<br />93-A Pine Burr Rd<br />Lumberton, MS 39455

                      Comment

                      Working...
                      X