I noticed when I first get my Honda F12 on the water and it is ideling it runs a bit rought until I give it some throttle then after a bit it is fine. If I run it a while then idle it is as smooth as can be. If I turn of the engine off for a bit then restart the idle is a bit rough again until I throttle a bit.. Does this sound ok or should I have Honda adjust my idle up a little during my 10hr service? It idles at about 1,000 RPMS or less which runs at about 1-2 mph.
Announcement
Collapse
No announcement yet.
After start idle rough
Collapse
X
-
Re: After start idle rough
Unless your stern is tied to the dock or you are on the trailer you should be getting more than 1-2 mph. I usually get 4-5. Although I wouldn't mind a little slower sometimes.
Incidentally if your stern is tied to the dock stop complaining. Relocating docks is one of the side effects of owning a Honda. :D
-Bill
Comment
-
Re: After start idle rough
your idle should be 1200 rpm + or - 100
also the ECM goes through a self diagnostic when the key is inserted. you will also hear the fuel pump pressurize the lines. allow this to finish before you start the ski. it takes about 1-2 seconds after you insert the key. sometimes if you try to start the ski before the self diagnosis test finishes, you may get an error codes on some of the older honda ski's.
the idle is easy to set, there is a black or white plastic knob on the end of the fuel rail. the turbo is one color and the non turbo is the other color, i think the turbo is black also i think the turbo knob is on the front of the rail and the non turbo is on the back of the rail. just turn is a 1/8 turn at a time until you get the average of 1200 RPM
Mike
Comment
Comment