Announcement

Collapse
No announcement yet.

How hard is it to remove motor from drive line

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • How hard is it to remove motor from drive line

    i am in the process of reomoving a motor from a 97 hull and installing it in a 99 gp hull and was wondering how to go about removing the motor from the drive line the easiest. any help would be greatly appreciated. just a quick rundown of the procedure would be good. i dont want to remove unnecessary parts if i dont have to.i have all the wires,motor mounts off already.
    thank

  • #2
    Re: How hard is it to remove motor from drive line

    Well try going here http://www.sbtontheweb.com/pdfs/y11001200npv.pdf
    its the engine removal install guide for the GP1200 Non power valve.

    Skip the parts that wouldnt pertain to you as you are not rebuilding a new motor. Its got the guts of what you need to do what you need. :P

    Good Luck and Gods Speed....

    Flyt
    So FaR!! So MuCh FuN!!!

    Factory 99' GP1200
    Riva Intake Grate
    Solas Impeller
    Everything Else Stock!!
    247+ Hours and counting.......

    Comment


    • #3
      Re: How hard is it to remove motor from drive line

      thanks for the reply- i switched everything over and all went well. i will fire the beast up tonight. i put a gp1200 motor into the 99 gp800 limited hull.
      cant wait to go out and rip it up.
      thanks
      don:D

      Comment


      • #4
        Re: How hard is it to remove motor from drive line

        if you don't mind me asking - what are you planning on doing with the 97 hull?

        is it damaged?

        Comment


        • #5
          Re: How hard is it to remove motor from drive line

          Sorry Its Gone..

          Comment


          • #6
            Re: How hard is it to remove motor from drive line

            Are you going to use the 155mm pump out of the 1200?
            J-me
            05 Bayliner 175
            98 GP 1200 Yamaha factory support hull, Lamey engine, Skat pump

            Comment


            • #7
              Re: How hard is it to remove motor from drive line

              Yes Everything Was Switched Over. The Only Thing I Have Extra Is The Fuel Tank.

              Comment

              Working...
              X