SBT Jetski Engines, Parts & Accessories

Results 1 to 2 of 2
  1. #1
    Oct 2001


    Just put the first tank of gas through my second engine from SBT, a Polaris 1050.
    Again am impressed with the quality and service, had to wait a couple of days this time for shipping, but it's summer and I'll bet a busy one. One leakey water jacket O-ring found on the flush kit, quickly remedied by tech support, was overnighted out that day.
    I highly recommend SBT!

    One comment on the installation manual:
    When installing a Polaris domestic tripple, I find that if you put the intake and carbs on before you install the exhaust manifold and pipe, it is a lot easier to hook up the throttle, oil pump, and choke cables. It also is much easier to adjust the oil pump. Also, you should put a picture in the manual showing the oil pump alignment marks so folks will check for proper adjustment.

  2. #2
    Mar 2003


    I'll take note, thanks!
    SBT Tech Support is here to help with your problems.
    We try to answer each question quickly and accurately.
    Please do not use Private Messaging for Tech Support, use the forums.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. My 2nd SBT 900 motor
    By cyberowl in forum The SBT Experience
    Replies: 2
    Last Post: 08-03-2006, 07:37 PM
  2. First Purchase from SBT
    By swishewk in forum The SBT Experience
    Replies: 1
    Last Post: 08-11-2004, 01:33 PM
  3. 1st sbt purchase
    By ryanpoole in forum The SBT Experience
    Replies: 0
    Last Post: 06-16-2004, 07:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts