SBT Jetski Engines, Parts & Accessories

Results 1 to 4 of 4
  1. #1
    Joined
    May 2005
    From
    Wi
    Posts
    7

    Default xl 1200 npv stinger/water jacket connection

    Hi, me again. I've installed the stinger elbow pipe coming off the manifold and am not sure about the connection of the water jacket section to the stinger. The red/orange colored inner exhaust sleeve of the jacketfits over the inner pipe of the stinger. It appears that the outer sleeve needs a collar clamp? if not I'll keep going. If so, how do you get the clamp on/tightened while keeping the outer rubber boot in tact? Hope this makes sense, Thanks again.

  2. #2
    Joined
    Jun 2002
    From
    Charlotte NC
    Posts
    1,868

    Default Re: xl 1200 npv stinger/water jacket connection

    Look here for parts diagrams for a xl1200 98'

    http://216.37.204.206/xtremepowerspo...p?Type=12&A=63
    Providing mobile JetSki service to the Charlotte / Lake Wylie area.

  3. #3
    Joined
    May 2005
    From
    Wi
    Posts
    7

    Default Re: xl 1200 npv stinger/water jacket connection

    Thanks for the reply. I have the diagram and it still is hard to say if you need clamp on the inner sleeve. If you do, is there a method for getting it onto the inner pipe?

  4. #4
    Joined
    Apr 2003
    From
    Delaware
    Posts
    242

    Default Re: xl 1200 npv stinger/water jacket connection

    Yes the orange coupler gets 2 clamps. You have the outter rubber boot on the pipe, but not in position. Tighten the orange coupler clamps then slide black boot into place and then tighten those two clamps.
    J-me
    05 Bayliner 175
    98 GP 1200 Yamaha factory support hull, Lamey engine, Skat pump

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •