Bill,
I finished the top end rebuild of my HX, and replaced the needles and seats, and rebuilt the carbs.
I've been breaking the engine in last few times out until today when I went WOT the rpms only reached 5900-6000, and the bike is noticably slower. I think my carbs settings are a little rich, Where should I start with my lows and highs? :emoticonn
When I cleaned the carbs the settings were high 1 1/4 and low 3/4s, but the pistons were over-sized, now has stock sbt pistons, and I used a stock sbt cylinder gasket..
The plug electrode is a dark black....
720 HX
Factory Pipe
R&D Head
2.0 needle
145 Main
67.5 Low
32 pop-off
Compression 150+
I finished the top end rebuild of my HX, and replaced the needles and seats, and rebuilt the carbs.
I've been breaking the engine in last few times out until today when I went WOT the rpms only reached 5900-6000, and the bike is noticably slower. I think my carbs settings are a little rich, Where should I start with my lows and highs? :emoticonn
When I cleaned the carbs the settings were high 1 1/4 and low 3/4s, but the pistons were over-sized, now has stock sbt pistons, and I used a stock sbt cylinder gasket..
The plug electrode is a dark black....
720 HX
Factory Pipe
R&D Head
2.0 needle
145 Main
67.5 Low
32 pop-off
Compression 150+
Comment