Hi. I am rebuilding an engine on a 94 XP 650. I had the cylinders bored to match the new pistons. However, the old pistons had broken off into small pieces in some areas. I am concerned that fragments could be inside the engine.
What is the best way to flush these potential fragments out of the system before I reassembled the top end?
Just want to make sure this thing runs good as I plan to keep it.
Thanks,
Joshua Cole
What is the best way to flush these potential fragments out of the system before I reassembled the top end?
Just want to make sure this thing runs good as I plan to keep it.
Thanks,
Joshua Cole
Comment