Yes a 440 or 550 will fit in that hull. You may have to fiberglass some engine mounts or there may already be places for them. We don't want the 300, but we have 440 and 550 for a slightly higher price without a core. :D
Announcement
Collapse
No announcement yet.
Kaw 440-550 motors
Collapse
X
-
I am just throwing around ideas on what project I could start. I have always wanted to get the stand up back in the water. I will contact sooner or later...money permitting [img]smile.gif[/img]
Joe St. Louis:
What do you mean by "but we have 440 and 550 for a slightly higher price without a core?" What all does this consist of? (i.e. crank, pistons)??
GT
Comment
-
I would go with the Factory Pipe 550 pipe and waterbox - I couldn't say what a good carb combo would be.
Comment
-
I have an old Kawasaki 300 jet ski. This one has the same hull as the 440 and 550. The 300 engine seized a long time ago and the hull has been sitting in the garage. I have rebuilt the engine a long time ago, but crapped out a week later. Anyways, I was wondering if a 440 or 550 motor would fit into the hull???
GT
Comment
Comment