Ok, so i've read the sticky on breakin in a new engine. but i still have questions.
it says taht there shoudl not be full throttle operation for the first 10 gallons of gas? but it says after the first gas tank, you can touch 100% when some gas tanks are over 15 gallons?
i have a 96 xp w/ a 9 gallon gas tank. how should i break it in?
i was thinking about following the same exact instructions:
Then begin varying the throttle position up and down, up to 20% throttle for a half hour. Then come back and let the engine cool off completely - it should be a good 30 min break. After it cools down, you may now ride it up to 50% throttle for another half hour or so. Then come back again and let it completely cool down again. Now you can go out and ride up to 90% throttle. Continue this for the remainder of the 10 gallons, never holding one throttle position for more than a few seconds
is 10 gallons considered a gas tank? i'm still very confused. can someone please explain this.
it says taht there shoudl not be full throttle operation for the first 10 gallons of gas? but it says after the first gas tank, you can touch 100% when some gas tanks are over 15 gallons?
i have a 96 xp w/ a 9 gallon gas tank. how should i break it in?
i was thinking about following the same exact instructions:
Then begin varying the throttle position up and down, up to 20% throttle for a half hour. Then come back and let the engine cool off completely - it should be a good 30 min break. After it cools down, you may now ride it up to 50% throttle for another half hour or so. Then come back again and let it completely cool down again. Now you can go out and ride up to 90% throttle. Continue this for the remainder of the 10 gallons, never holding one throttle position for more than a few seconds
is 10 gallons considered a gas tank? i'm still very confused. can someone please explain this.
Comment