Announcement

Collapse
No announcement yet.

Grease Fitting Location (94 Wave Raider)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Grease Fitting Location (94 Wave Raider)

    Where is the grease fitting for the drive shaft on the rear of the ski (behind impeller)? I see a cone-shaped cap that has 3 bolts on it's circumference and one bolt in the center. I was going to take the center bolt out and place a grease fitting here but when I did, clean grease ran out like it was under pressure. Where do I need to supply grease to these bearings / seals?

    My old Kawasaki's have a fitting in the center that you can see when looking into the pump nozzle from the rear.

    I am aware of the drive shaft holder fitting that supplies grease to the bearings where the shaft goes thru the hull (behind engine coupler).

  • #2
    It doesn't have one. You pack the cone with grease when you install it - it doesn't require maint.
    SBT Tech Support is here to help with your problems.
    We try to answer each question quickly and accurately.
    Please do not use Private Messaging for Tech Support, use the forums.

    Comment

    Working...
    X