If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I AM INSTALLING TO NEW 1100 SBT MOTORS IN MY WAVE RAIDERS AND WONDERING IF I SHOULD GET RID OF THE OIL PUMP AND USE PRE MIX INSTEAD IF I USE PRE MIX DO I HAVE TO DO ANYTHING WITH THE CARBS.
THANKS IN ADVANCE
Nothing special, no. On that ski the only difference is the hassle of pre-mix.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
The best thing about premix is that you dont have to worry about what gas/oil mix your boat is getting, and its one less thing to go wrong and fry a motor. No cables/rods/check valves/hoses/oil pumps to fail>>>
The biggest problem with running premix is, YOU need to be the one fillin the tank to make sure the right stuff is going in!!
Running premix does lean out the fuel supply a little bit, since what is going through your carb jets is now fuel and oil, Which means less fuel. (Less than an 1/8 of a turn on the screws)
However, if the boat is stock, its probably a little on the rich side anyways....so dont sweat it.
<a href="http://www.wetwolf.com/" target="_new"><img src="http://www.wetwolf.com/images/hurrsigpic.gif" width="400" height="100"></a><br /><br />Bruce Wolford<br />Wet Wolf Technologies - Purveyor of Performance Pump Parts<br />(509) 280-5444<br /><a href="http://www.wetwolf.com" target="_blank">Wet Wolf Tech</a><br /><br />PWC Race Director<br />Northwest Water Competition<br /> <a href="http://www.nwh2oracer.com/ijsba" target="_blank">http://www.nwh2oracer.com</a>
Comment