I am following the SBT break in procedure on my new motor and I have done the first two 30 minute cycles. Since I didn't know if the injection was working, I put pre-mix in as directed for a pre-mix engine. Well, the injection is working.
Anyway, here are the plugs - do they look ok?
edit: I cant see the images. try this
http://www.pbase.com/st__stephen/image/66235280
http://www.pbase.com/st__stephen/image/66235284
Also, the pisser water is coming out very hot, looks like it is steaming, can only put my hand under it for a few seconds. Is this normal? It's not that hot on my sea-doo.
Thanks for any help,
Stephen
Anyway, here are the plugs - do they look ok?
edit: I cant see the images. try this
http://www.pbase.com/st__stephen/image/66235280
http://www.pbase.com/st__stephen/image/66235284
Also, the pisser water is coming out very hot, looks like it is steaming, can only put my hand under it for a few seconds. Is this normal? It's not that hot on my sea-doo.
Thanks for any help,
Stephen
Comment