This is a little strange and I hope some one can help me out. The digital gauge on my machine is not working. When I push the start button some things flash and when I let off the start button it goes blank. I disconnected the starter cable from the solenoid and I pushed the start button and as long as I continued to hold down the start button the gauge worked fine. I could change the modes and see all the information that I needed. When I let up on the start button the gauge would then again go blank.
I was wondering if anyone has experienced this type of issue.
Thanks in advance for any help you can provide.
I was wondering if anyone has experienced this type of issue.
Thanks in advance for any help you can provide.