Announcement

Collapse
No announcement yet.

Stock Carb Settings - 701

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Stock Carb Settings - 701

    On the carb settings chart is says:

    High Speed – 5/8(M), 1-1/8(P) +/- ¼

    What do the (M) and (P) stand for?

  • #2
    (M) Mag, front where the magneto is
    (C) Center
    (P) PTO, rear, where the PTO is
    SBT Tech Support is here to help with your problems.
    We try to answer each question quickly and accurately.
    Please do not use Private Messaging for Tech Support, use the forums.

    Comment


    • #3
      Re: Stock Carb Settings - 701

      My high is set at 1/2 turn out and the black screw on the other side is 1 full turn out.I Have a 1990 Waverunner III 650 engine.
      Is this the right settings.
      This is a new SBT engine I just bought and have not taken it out on the water yet.Reading the forms I see that if it is not set right I can mess my engine up and I do not want to pull it again.I also put a block off plate and use mix oil now.
      Please advise me what is the correct settings.
      Thanks Kenny

      Comment


      • #4
        Re: Stock Carb Settings - 701

        On a 650, both screws need to be out 1 1/2 turns.
        SBT Tech Support is here to help with your problems.
        We try to answer each question quickly and accurately.
        Please do not use Private Messaging for Tech Support, use the forums.

        Comment

        Working...
        X