If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
(M) Mag, front where the magneto is
(C) Center
(P) PTO, rear, where the PTO is
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
My high is set at 1/2 turn out and the black screw on the other side is 1 full turn out.I Have a 1990 Waverunner III 650 engine.
Is this the right settings.
This is a new SBT engine I just bought and have not taken it out on the water yet.Reading the forms I see that if it is not set right I can mess my engine up and I do not want to pull it again.I also put a block off plate and use mix oil now.
Please advise me what is the correct settings.
Thanks Kenny
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Comment