Announcement

Collapse
No announcement yet.

re a 04 xl 700 compression

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • re a 04 xl 700 compression

    what should the compression be on a 04 xl700 guys

  • #2
    Re: re a 04 xl 700 compression

    as low as 120 as high as 160
    SBT Tech Support is here to help with your problems.
    We try to answer each question quickly and accurately.
    Please do not use Private Messaging for Tech Support, use the forums.

    Comment


    • #3
      Re: re a 04 xl 700 compression

      My compression is 135 and 140 the motor runs fine then bogs out after about 5 minutes and wont start till it sits for awhile then will run for short time agian. the water flow seems good out the pisser where do I look next ?

      Comment


      • #4
        Re: re a 04 xl 700 compression

        Check your coils (Pulse and charging) measure directly after you get the problem and see if one of them is out of spec.

        Coils are located on the stator, wire connections are in the electrical box, get a manual somewhere for wire colors and specs.

        Somewhere on this forum is a link to manuals.

        Comment


        • #5
          Re: re a 04 xl 700 compression

          This is in our weekly tech tip area.
          The SBT tech department recommends that when performing any engine swap or top end rebuild, the installer should always have a factory repair manual present to complete the job at a professional level. This is a great link that has been passed on to us.

          jmfiskin.com/manuals/
          __________________
          SBT Tech Support is here to help with your problems.
          We try to answer each question quickly and accurately.
          Please do not use Private Messaging for Tech Support, use the forums.

          Comment

          Working...
          X