Announcement

Collapse
No announcement yet.

Where to Start 98 GTI

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Re: Where to Start 98 GTI

    Says he had to put new power valve in. Will water test in a little while. could that have been the issue the whole time? What should the powervalve cost me? It was 380 for a carb job Im now not sure I even needed or got. Stinks dealng with guys you dont know. New shop 20 miles close than olld one. I guess If he trats me right on the back end Ill be ok but he should have water tested it to start with. 10 minute put in. Really appreciate all the time Dan Thanks

    Comment


    • #32
      Re: Where to Start 98 GTI

      NEW Rave valve?? Eh.. Did he give you back the old parts like he's supposed to?

      The most those will ever need is a cleaning and a replacement of the o-rings and internal bellow.
      Dan Solie -
      04 RXP (the "Instigator")
      94 xp (freestyle mods)
      95 xp (faster than the 94)
      JS550 (the toothpick & the loaner)

      For FREE Seadoo Manuals - Click HERE!!!!

      http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

      **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

      Comment


      • #33
        Re: Where to Start 98 GTI

        dint show for the water test , but had some thunder storms (benfit of the the doubt). will see what the morning brings.

        Comment


        • #34
          Re: Where to Start 98 GTI

          Ok new bellow gave a torn one. No joy. pulled carbs again and rear carb would not pop off leak but to release. Ran some errands and when I came back ski back together. ran real strong out of water. Tried backing it down running and starting now idels fine but still not transitioning 3500 wide open and really boggy pulll it up while running jumps right back up. Asked about low speed screw said it wouldnt make a difference will try my self.

          Comment


          • #35
            Re: Where to Start 98 GTI

            New revalation took to ramp starting trouble again after adjusting screw. started messing with on turning back and forth and kind of half between off and on ski jumps upto 7k. Take it out on water runs at 7k but onlt 30MPH wide open. Bad valve lines?

            Comment


            • #36
              Re: Where to Start 98 GTI

              If it runs 7k but only 30, then it's something in the pump...

              Wait.. What's the RPM in the water... Still 3500?
              Dan Solie -
              04 RXP (the "Instigator")
              94 xp (freestyle mods)
              95 xp (faster than the 94)
              JS550 (the toothpick & the loaner)

              For FREE Seadoo Manuals - Click HERE!!!!

              http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

              **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

              Comment


              • #37
                Re: Where to Start 98 GTI

                No have it up 7k now but only after I twist the on off back and forth.

                Comment


                • #38
                  Re: Where to Start 98 GTI

                  on off.. like the fuel selector?!?! If so... BINGO!! Clean it!
                  Dan Solie -
                  04 RXP (the "Instigator")
                  94 xp (freestyle mods)
                  95 xp (faster than the 94)
                  JS550 (the toothpick & the loaner)

                  For FREE Seadoo Manuals - Click HERE!!!!

                  http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

                  **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

                  Comment


                  • #39
                    Re: Where to Start 98 GTI

                    Yes fuel selector. Just take the 3 lines of and put it through parts cleaner?

                    Comment


                    • #40
                      Re: Where to Start 98 GTI

                      Ok cleaned slector ski runs up now 7k but still 30 MPH. Wear ring or some other pump problem?

                      Comment


                      • #41
                        Re: Where to Start 98 GTI

                        Yup.. wear ring, impeller or stripped driveshaft splines.

                        Getting closer!
                        Dan Solie -
                        04 RXP (the "Instigator")
                        94 xp (freestyle mods)
                        95 xp (faster than the 94)
                        JS550 (the toothpick & the loaner)

                        For FREE Seadoo Manuals - Click HERE!!!!

                        http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

                        **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

                        Comment


                        • #42
                          Re: Where to Start 98 GTI

                          Will the wear ring cross reference to another year/model? unable to find in stock local.

                          Comment


                          • #43
                            Re: Where to Start 98 GTI

                            Any 140mm pump wear ring will work.. That cross references to a lot of ski's..
                            Dan Solie -
                            04 RXP (the "Instigator")
                            94 xp (freestyle mods)
                            95 xp (faster than the 94)
                            JS550 (the toothpick & the loaner)

                            For FREE Seadoo Manuals - Click HERE!!!!

                            http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

                            **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

                            Comment


                            • #44
                              Re: Where to Start 98 GTI

                              Ok got one and its in. Of course now battery is low from days worth of cranking. Have it on the charger. So we have rebuilt carbs (torn down twice), New bellow in rave, cleaned lines and fuel selector and put in a new wear ring. When it comes off the charger if it doesnt run watch for Utube posting. It will be spectacular being pushed off the highest cable bridge in north america.

                              Comment


                              • #45
                                Re: Where to Start 98 GTI

                                How did the old ring look? How did the impeller look.. Was the pump oil milky?
                                Dan Solie -
                                04 RXP (the "Instigator")
                                94 xp (freestyle mods)
                                95 xp (faster than the 94)
                                JS550 (the toothpick & the loaner)

                                For FREE Seadoo Manuals - Click HERE!!!!

                                http://www.tripleateam.com/water/v/U...ery/Dan-Solie/

                                **** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****

                                Comment

                                Working...
                                X