I just COMPLETLY rebuilt a 1999 XL1200LTD that i bought for cheap. I'M NEW to jet skiing... the ski starts up and runs great,,, after about 15 min the warning arrives... I know it already has the D-Plate on it but is there a improper way to install it..( with the block off side of the D-plate towards the cencor or the open side towards??) ski only get to 113 degress and goes no higher....
Also when i flush it i've notice no water coming out of the two front holes in the ski,,, it has all new gaskets and i took a power washer to all openings prior to putting back together, so no clogging ,,, I have water at the top of the exhaust manifold cause i removed one rubber tude just to make shure !!!
ANY AND ALL HELP ON HOW TO FIX THIS ISSUE OR WHAT ELSE IT MAY BE WOULD BE GREATLY APPRECATIED !!!
Also when i flush it i've notice no water coming out of the two front holes in the ski,,, it has all new gaskets and i took a power washer to all openings prior to putting back together, so no clogging ,,, I have water at the top of the exhaust manifold cause i removed one rubber tude just to make shure !!!
ANY AND ALL HELP ON HOW TO FIX THIS ISSUE OR WHAT ELSE IT MAY BE WOULD BE GREATLY APPRECATIED !!!
Comment