I just rebuilt the carbs on my 96 SL900 to try and fix the hard starting issue.
Everything seemed to go very well, but after getting them back on I can't get it to idle. Accelerator pump is pumping file with throttle squeeze, and I put the idle mixture screws back to the same setting before disassembly.
Carbs were disassembled, soaked, washed, rinsed, and blown clean.
I used Winderosa carb kits.
Here are some symptoms.
Need to pump throttle for it to start.
Runs great after it comes off idle.
If I pump the gas I can get it to stay running and come off idle.
I can see flames in the carbs when I try to get it to idle or come off idle.
Is this an adjustment issue, or did I screw something up during the rebuild?
Thanks, Cory
Everything seemed to go very well, but after getting them back on I can't get it to idle. Accelerator pump is pumping file with throttle squeeze, and I put the idle mixture screws back to the same setting before disassembly.
Carbs were disassembled, soaked, washed, rinsed, and blown clean.
I used Winderosa carb kits.
Here are some symptoms.
Need to pump throttle for it to start.
Runs great after it comes off idle.
If I pump the gas I can get it to stay running and come off idle.
I can see flames in the carbs when I try to get it to idle or come off idle.
Is this an adjustment issue, or did I screw something up during the rebuild?
Thanks, Cory
Comment