I've taken the fuel pump module out to replace the fuel pump itself, and it was successful, however I wanted to perform a simple OHMS reading on the fuel sensor while I had it out. It's not throwing any codes or anything, just wanted to make sure it was within specs. After I downloaded the Seadoo shop service manual, I found it extremely helpful except for the fact that I couldn't find anywhere in the manual where it said what the range specs should be. So, I found that at all the way down (empty), it read 90 ohms, all the way up (full), it read 5 ohms. just wondering if that's within reason. Maybe i'm being a little too picky. What a ya'll think?
Announcement
Collapse
No announcement yet.
952 XP DI Fuel Sensor Level Test
Collapse
X
Comment