Tweet
I failed to remove the PTO flywheel before the engine was completely disassembled. Now I have to replace an o-ring on the crankshaft bearing nearest to this flywheel, and have to remove it. How do you recommend doing this? The manual that I have recommends mounting a puller on the front flywheel and turning the PTO flywheel off. However, it does not go into detail. I cannot see any bolts or anything else holding the PTO flywheel, so should I remove it using the impeller tool?
-
-
stop the rear cylinder using rope in the plug hole. Use a chain wrech and breaker bar to remove the ptoSBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums. -
I meant completely disassembled, down to the crankshaft. What do you suggest now?Comment
-
You need to put the crank in a large vise to hold it.SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.Comment
-
I did this myself . Even though I had a big vise and a big table,I had to apply heat to the fly wheel to break it loose.Comment
Comment