S/D 800 pump

[The Kid]

I blew the barrings out of my pump pretty bad, I beleive that there is 2 barrings that are press fit in(the shaft that turns the prop runs through these) The bearing are located behind the cone.
What I need to know is: are there only 2 barrings in there?
What kind of barrings are they?
And how much do they cost?

[Bryan Glynn]

You can find the complete schematics with part numbers for your ski at www.hlsm.com and www.epowersports.com

[Joe St. Louis]

Yes there are only two Bearings in your pump. They are easy to remove, but you need a special tool to install. You also have one seal that should be replaced at that time. :D

[steve]

Actually Joe there are 3 bearings in that pump. Two are pressed in and one thrust bearing.

[Joe St. Louis]

You are absolutely right. How careless of me to forget the bearing that falls out in your hand when you pull the pump shaft. That should be replaced also.