Does anyone know what the pop off pressure should be on a 90 650SX Kawasaki. Its got the 28mm Keihin CDK and is all stock. When I first tried to start it it would only run when pumping the primer. I found that the pop off pressure was 30 psi and it would never open up at all. I dropped it down to 20 psi and it seems to run fine now except when restarting after the motor is warm. Acts like its flooded.
Announcement
Collapse
No announcement yet.
Pop off pressure
Collapse
X
-
Found this on the net... although Mikuni require a special adapter...
" A while back I read a way to build a cost efficient pop off gauge.
Go to a medical supply store and buy a blood pressure cuff
bulb with a built-in relief valve (about $4.00 in my area), a 0-15 or 20
lb gauge, tubing (I used quarter inch automotive fuel hose, one T to fit
tubing, and then put it together: Bulb, hose to T, out the top of T to the
gauge, the other side of the T to the carb.
Total cost = say $18 plus or minus.
"
Take care,
-Skexies
Comment
Comment