Hi all
i have taken the head off of my 92 x-2 and I have found that the pistons and liners are worn (It was running at 80psi!!!). it has 1.25 on the top of both pistons. Should I get the block rebored out to the next size then order new pistons and gaskets? Is this the normal way of doing a top end rebuild?
Also i have a westcoast head on there and it has two o rings round the cylinder. Will these come with the top end gasket set?
Please reply
Rich
i have taken the head off of my 92 x-2 and I have found that the pistons and liners are worn (It was running at 80psi!!!). it has 1.25 on the top of both pistons. Should I get the block rebored out to the next size then order new pistons and gaskets? Is this the normal way of doing a top end rebuild?
Also i have a westcoast head on there and it has two o rings round the cylinder. Will these come with the top end gasket set?
Please reply
Rich
Comment