If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Nothing is required for a .5mm over, but yes the head must be cut slightly for anything above that. It's not a big deal, a $50 charge at a local shop usually.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
is that only for a 99 gp1200 or is that for all of them in general . I have a tigershark 640 that i just got cylinders and piston kit from you guys it is 1.0 mm over .
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Comment