1995 Kawasaki 650 cc X2 Holing water

[badams270]

Does anyone know how you drain the water out of the ski after removing from the water. I can't find a plug or anything.

[WATERCRAFTSERVICES]

Re: 1995 Kawasaki 650 cc X2 Holing water

The x2 does not have drain plugs. Use a siphon hose or shop vac to get the water out. Then think about installing a small bilge pump. You are limited on space to mount it. I have found the best place to mount it is the right side of the engine compartment just behind and below the carb. It was mandatory in the days of x2 racing to have a very good bilge pump running constantly to keep them dry. Works very well.

[JaggerX2]

Re: 1995 Kawasaki 650 cc X2 Holing water

The x2 does not have drain plugs..

Not true! There is a drain for the motor crankcase to get any water out of it . It is up by the exhaust. Pull the knob and turn engine over blowing water out this drain. As far as draing the engine compartment there is s stock bilge that uses siphoning effect fro the pump but ski has to be moving. Buy a good rule 1200gpm pump and blow that water out the side so fast that you create a new trick!