If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
My mechanic is afraid to use the Polaris software on the kawi. He thinks the software has to know the jetski model number and that is it is not correct it might set it up or change the setup based on a Polaris model. Is this correct?
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
I know this thread is a couple of years ago but I was hoping someone had newer Polaris software. I have a 2004 Virage i with a new SBT engine that's experiencing some minor running issues and we wanted to see if there are any error codes stored in the computer. I made the cable (there's s a wiring diagram for the cable in the service manual; I'll post the how-to if I can ever get meaningful data out of the ECU) and got as far as "A DIAGNOSTIC SOFTWARE UPDATE IS REQUIRED TO ACCESS THIS EMM" with both the polaris v2.0 software and the kawasaki software that was posted.
same message here "update required"...doesn't seem to be any updates for the older stuff, and Polaris digital wrench isn't available to any independents
It would probably cost you just as much to make them - they are BITCH!
Are these for a tigershark, kawasaki, or polaris? I'm looking for a cable for a tigershark... Does anyone have a diagram for this cable or have one for sale?
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Comment