Have about 7 Hrs on the new SBT motor and it is locked up. I have been watching the compression and the plugs since I installed it and both looked good. Today I ran it around the lake with no problem but what was doing a lot of the circle stuff and and digging in the water when it locked up. I think I may have been doing the same thing the day before it blew last time. The last time it blew a part of the front (#1) piston skirt came off. This time the #1 plug looked very white (Very Lean) and the other two plugs looked fine. Is there something that goes bad in an ULTRA that would lean it out when doing multiple
circles (Leaning Hard) ??
circles (Leaning Hard) ??
Comment