Tweet
I recently installed a new sbt motor in an 2002 ultra 150. went to start for first time and turned over 8 to 10 times then it quit. checked and had 12volts on starter so I thought starter is bad , pulled out starter ,took it apart and the insides were destroyed. Installed a new starter , turned over 8 to 10 times and the starter did the same thing. what is causing this? would being out of time cause this? i lined up the dots on the gears just like the installation guide said. Please Help!!!
-
-
Re: locking up starter
By torn up... Do u mean the armature and rotor or the drive gear?
I am sure you hand turned the engine to check it out before you installed it. Out of timing would not destroy a started but excessive torque overload or wrong voltage would..
This is getting expensive...
Have A Great Day!! -
Re: locking up starter
you will need to make sure that the one way clutch is in the right direction and that is not damaged.SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.Comment
-
Re: locking up starter
how can i tell if the one way clutch is in the wrong way?Comment
-
Re: locking up starter
OKOriginally posted by Technical Support View Post
Let me see a one way clutch..
Can you give details? I'm curious...
Have A Great Day!!
/Comment
Comment