If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a kawaski ultra 150 and I get 100 on all thre cylinders it runs fine out of water but when you put a load on it it doesn't move should I replace the top end? Thanks Tim
If your readings are correct then your too low, time to rebuild
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Tweet
Comment