Tweet
I have a 94 Kawasaki 750 SS XI I would like to install a primer kit. Could anyone give me some feedback also is there an installation procedure available on the internet.
-
-
Primers are great!
Primer Installation:
1) Remove the carbs from the ski (see the Install Guides).
2) Remove the choke butterflies from the shaft. Tap the screws with a screwdriver and hammer prior to loosening.
3) Remove the choke shafts, cam and cable.
4) Remove the choke knob and cable (optional).
5) Often the best place for the primer pump is where the choke knob was. Where ever you want it, drill out the appropriately sized hole in the hull for the pump. A wood bit works very well for this.
6) Install the primer pump in the hull.
7) Tee into the Fuel Reserve line between the tank and the fuel petcock too feed the pump.
8) Install primer fitting into the carbs and reinstall them on the ski.
9) Install the primer lines from the pump to the carbs.
Comment