Replacement SBT motor mount...

[javiert99]

http://www.sbtontheweb.com/Merchant2...tegory_Code=37

I take it that's the correct mount for my sl900 right? It's the only one that looks close so I figure that's it? :)

One of my mounts snapped when pulling the motor (my assistant in pulling the engine kinda let the motor flop against the mount bolt). Just looking for a replacement.

[douglee25]

Re: Replacement SBT motor mount...

http://www.sbtontheweb.com/Merchant2...tegory_Code=37

I take it that's the correct mount for my sl900 right? It's the only one that looks close so I figure that's it? :)

One of my mounts snapped when pulling the motor (my assistant in pulling the engine kinda let the motor flop against the mount bolt). Just looking for a replacement.

That's the one. You may have to cut off that little stud though.

Doug

[beerdart]

Re: Replacement SBT motor mount...

Check this out

http://cgi.ebay.com/ebaymotors/ws/eB...category=56422

[javiert99]

Re: Replacement SBT motor mount...

Check this out

http://cgi.ebay.com/ebaymotors/ws/eB...category=56422

Only problem is I need it tomorrow :)

doug, I think mine has the stud as well. If not I've got a air cutoff tool :)

[Technical Support]

Re: Replacement SBT motor mount...

There is no need to modify anything, these are the correct mounts.

[javiert99]

Re: Replacement SBT motor mount...

I'll be calling in a few minutes to place the order...

*edit* ordered!

[douglee25]

Re: Replacement SBT motor mount...

There is no need to modify anything, these are the correct mounts.

Hmmmm.... I know when I ordered the mounts for my '93 sl750, the ones listed in the picture were wrong (needed the bent ones opposed to the straight ones as suggested). When I ordered the bent ones, they had the stud as seen. Interestingly enough, the engine would not fit unless these studs were ground off.

Doug

[Technical Support]

Re: Replacement SBT motor mount...

That's simply because you used the wrong mount. a 1993 SL750 takes these and you should have separated your originals from the base plate - or someone switched them incorrectly before you: http://www.sbtontheweb.com/Merchant2...tegory_Code=37

[douglee25]

Re: Replacement SBT motor mount...

Ahhhh, I see what you're saying. The straight ones bolt into the original base plates opposed to the new style which is all one piece. Well, nevertheless, I guess my '93 is updated with the new style.:D


Doug