I flipped my ski upside down in the lake - to cut away the piece of ski rope that was wrapped around the drive shaft and jammed in the impeller. In doing this I got water in the MFD display and also in the main electrical box.
Now it seems to be stuck in limp mode , and the MFD is all messed up.
I opened up the box to dry it out. Is there any way to save the MFD?
Is there any way to temporarily run without the MFD?
Will a messed up MFD cause the limp mode condition?
It is a '97 SL1050.
All advice and comments will be greatly appreciated.
JB - in Holland , MI
Now it seems to be stuck in limp mode , and the MFD is all messed up.
I opened up the box to dry it out. Is there any way to save the MFD?
Is there any way to temporarily run without the MFD?
Will a messed up MFD cause the limp mode condition?
It is a '97 SL1050.
All advice and comments will be greatly appreciated.
JB - in Holland , MI
Comment