If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had the wear ring replaced on my 4-TEC. I went to flush it and the port that the flushing kit screws in to is missing the internal threads to connect the flushing kit. Did the dealer leave something off after replacing the wear ring?
No. Are you sure you are going into the correct port?
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Tweet
Comment