Well, my foray into the world of PWCs insn't going very well. Just bought the above ski and it runs like horse.... No accelleration until it sort of "kicks in" after a couple of minutes to get on a plane. No thumb position seems to matter (doesn't bog or hesitate per se) but its like it doesn't have power. Like its running on only one cylinder. But then the second kicks in. One on a plane, as long as you don't slow down, it seems to run fine. Then, when warm, it doesn't start. Plugs wet.
Since this is new (to me), should I just go ahead and rebuild the carbs to make sure they are ok? Anything else I should check/do to fix above problem, and/or avert future unkown problems?
Thanks in advance!
Dave
PS, seems to have a Rossier pipe, msd water injection (which has been off, but doesn't seem to have any affect either way) as well as an aftermarket intake. I sure wish it was stock... do these parts affect what the carb settings should be initially set at if I decide to rebuild them??
Since this is new (to me), should I just go ahead and rebuild the carbs to make sure they are ok? Anything else I should check/do to fix above problem, and/or avert future unkown problems?
Thanks in advance!
Dave
PS, seems to have a Rossier pipe, msd water injection (which has been off, but doesn't seem to have any affect either way) as well as an aftermarket intake. I sure wish it was stock... do these parts affect what the carb settings should be initially set at if I decide to rebuild them??
Comment