Tweet
Put new plugs in the boat, it won't idle. In order for it to start, you have to give it atleast 1/4 throttle. Fuel issue? Pump and drive shaft are straight and ok. Brand new wear ring. Engine was full of water when I received it, but I have since got that out. Oil is still a little milky. Suggestions?
-
-
Re: GTX 4-TEC help
Suggestions? Don't run it with milky oil.Bill O'Neal <br>
WCM
<a href="http://www.watercraftmagic.com" -
Re: GTX 4-TEC help
I have changed it 5 times and it is still milky... Yes I have cranked it over and sucked it all out
Comment
-
Re: GTX 4-TEC help
Pull the engine, remove the oil plug in the bottom of the motor, flush out with kerosine, replace the plug and oil and filter.Bill O'Neal <br>
WCM
<a href="http://www.watercraftmagic.com"Comment
-
Re: GTX 4-TEC help
Think that is the running problem?
Comment
-
Re: GTX 4-TEC help
At least one of them, yes. If you got that much water in your enging, obviously something very bad happened. Most likely you have more issue - you need to go over everything - but don't expect it to be like a 2 stroke - just fire it up and run it. Doesn't happen with 4's.SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.Comment
Comment