Greetings;
In overhauling my new `96 Challenger, I noticed two passages on the top side of the pump and venturi housings. On the pump housing, they open to the water above pump housing. In the venturi, they lead into the inside of the venturi, near the exit. One passage is completely blocked on the venturi (with aluminum, not foreign material), while the other side has a pinhole opening thru it...photo at http://www.flickr.com/photos/1054268...7602318341416/
Should these be fully blocked, or is this a sloppy casting---should they be open all the way thru the venturi?
In overhauling my new `96 Challenger, I noticed two passages on the top side of the pump and venturi housings. On the pump housing, they open to the water above pump housing. In the venturi, they lead into the inside of the venturi, near the exit. One passage is completely blocked on the venturi (with aluminum, not foreign material), while the other side has a pinhole opening thru it...photo at http://www.flickr.com/photos/1054268...7602318341416/
Should these be fully blocked, or is this a sloppy casting---should they be open all the way thru the venturi?
Comment