I have a 97 GTX just put a new SBT engine in it. It will start but not idle up. when I checked the plugs it looks like the front cylinder is firing but the back is not. I put carb. kit in. but cant tell if its getting gas or not. Best I could tell in the sunlight it was getting a spark. anyhelp would be appreciated. thanks.
Announcement
Collapse
No announcement yet.
97 GTX running on one cylinder
Collapse
X
-
Re: 97 GTX running on one cylinder
Did you rebuild the carbs correctly (it's a dual carb right?)?
Did you check the pop-off of the carbs? If your pop-off on the rear carb is too high, then it won't allow fuel into the fuel circuits, hence, not getting fuel into the motor.
Also, is it timed correctly?Dan Solie -
04 RXP (the "Instigator")
94 xp (freestyle mods)
95 xp (faster than the 94)
JS550 (the toothpick & the loaner)
For FREE Seadoo Manuals - Click HERE!!!!
http://www.tripleateam.com/water/v/U...ery/Dan-Solie/
**** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****
Comment
-
Re: 97 GTX running on one cylinder
Not really.. The gauge is not too expensive. You can always pull the carbs and take them into a local dealer and ask them to check the PO. Takes all of 5 minutes to do, but it is the difference between your motor running, or not running.Dan Solie -
04 RXP (the "Instigator")
94 xp (freestyle mods)
95 xp (faster than the 94)
JS550 (the toothpick & the loaner)
For FREE Seadoo Manuals - Click HERE!!!!
http://www.tripleateam.com/water/v/U...ery/Dan-Solie/
**** Please do not PM me. I don't do PM's.... Please post your question on the correct forum so that all can see and learn. Thanks! ****
Comment
Comment