If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No, the top caps and springs are external parts, you will need to replace them.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
WHY were you running it without the parts yet??? YES PARK IT! Sit on your hands! lol
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Well you just found your mess - and yes I'll have to be more specific in the future I guess. And no, it won't harm the ENGINE.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Steve,
Remember when I said your performance would suffer with a torn bellows?
Well what happened was your rave valve was not retracting because of the faulty bellows. That allows the valve to hang down in the exhaust port. The vlave gets hot and melts the plastic piston.
These motors will not work correctly if the rave valves are not functioning.
Bill O'Neal WCM
<a href="http://www.watercraftmagic.com" target="_blank">www.watercraftmagic.com</a>
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
I got my new RAVE assemblys back on, but i'm a little concerned about what i seen on the mag valve.
The outer edges were of clean metal, as if they were grinding on the walls, and one side had a chunk of metal out of it...can't tell if it melted or just broke apart.
Should i be concerned about that chunk missing being in my motor? It's not a big chunk.......about a 1/4 inch long, 1/8 wide and maybe 1-2mm deep, hard to say.
Also, i was tuning this thing not knowing this valve was messed up........should i go back to stock setting and start over, or is there no affect?
Comment