will not start

[tigger]

just replaced the engine ,rebuilt the carbs, changed plugs and gaped trimmed plug wires.I pulled the boot off of the front cyc. plug wire can not get a spark of any kind can my control module be bad. Thanks for your help tigger

[Colin GSXL]

If the ski was running up to when it needed the rebuild then you've probably put something back together wrong.

[tigger]

it died in the water last summer thats when I checked the compession it was down to 85 psi plus i put a new battery this year it started one time when I had a new lanyard programed at the dealer now like Isaid no fire thanks

[tigger]

followed all the instructions on timing, tick marks, torques

[Technical Support]

Check your voltage at the battery while cranking.

[ccwhit7]

check rear electrical box

[Bill O'Neal]

It helps to know what year and model Sea Doo you are talking about.

[tigger]

1997 gts

[tigger]

checked battery 12.9 volts when cranking

[tigger]

97 gts still will not start disconnected the battery, hooked straight to the leads it will turn over for 2or 3 secs then drop out. any help would be thankful. plus put a new control module.

[Bill O'Neal]

Maybe the starter is shot and taking all the power away from the ignition?

[tigger]

have just replaced the starter,sanded all conections everything is tight but still not getting fire to the plugs.

[Bill O'Neal]

Check the pin connectors at the mag cover. Sometimes a pin gets pushed back in the duetche connector and dosen't make contact.

[tigger]

Which is correct, 147 deg. or 130 deg timing for the rotary valve a 1997 gts. I have read in one book it should be 130, and another one 147. Maybe this will help this thing running.

[Technical Support]

147