Well if you guys haven't been following my Tigershark problems, I have the 96 Montego in which the rear bearing disentegrated on me. I finally got all the parts in to replace: driveshaft, impeller, wear ring, bearings and seals etc. I have a few questions that I don't see clearly in the manual. Pls help!
1.) In the Montego diagram of the pump assembly it appears that the rear seal is 2 pieces. I only have one to put in there. Explain?
2.) How far do I push the FRONT seal in? I pushed the seal in flush with the edge but there is space behind it between the bearing and seal. How much do I push it in?
3.) The new S/S impeller doesn't have the big 30mm nut on the end to tighten it down like the old one. Is hand tightening good enough? How do I tighten it down good?
Thx for the help guys. I'm trying to get it all together before this weekend to get one last ride in. I may be wearing my toboggan and sweatshirt out there, but I'll be riding!
1.) In the Montego diagram of the pump assembly it appears that the rear seal is 2 pieces. I only have one to put in there. Explain?
2.) How far do I push the FRONT seal in? I pushed the seal in flush with the edge but there is space behind it between the bearing and seal. How much do I push it in?
3.) The new S/S impeller doesn't have the big 30mm nut on the end to tighten it down like the old one. Is hand tightening good enough? How do I tighten it down good?
Thx for the help guys. I'm trying to get it all together before this weekend to get one last ride in. I may be wearing my toboggan and sweatshirt out there, but I'll be riding!
Comment