Hi, me again. I've installed the stinger elbow pipe coming off the manifold and am not sure about the connection of the water jacket section to the stinger. The red/orange colored inner exhaust sleeve of the jacketfits over the inner pipe of the stinger. It appears that the outer sleeve needs a collar clamp? if not I'll keep going. If so, how do you get the clamp on/tightened while keeping the outer rubber boot in tact? Hope this makes sense, Thanks again.
Announcement
Collapse
No announcement yet.
xl 1200 npv stinger/water jacket connection
Collapse
X
-
Re: xl 1200 npv stinger/water jacket connection
Look here for parts diagrams for a xl1200 98'
http://216.37.204.206/xtremepowerspo...p?Type=12&A=63Providing mobile JetSki service to the Charlotte / Lake Wylie area.
-
Re: xl 1200 npv stinger/water jacket connection
Yes the orange coupler gets 2 clamps. You have the outter rubber boot on the pipe, but not in position. Tighten the orange coupler clamps then slide black boot into place and then tighten those two clamps.J-me
05 Bayliner 175
98 GP 1200 Yamaha factory support hull, Lamey engine, Skat pump
Comment
Comment