Originally posted by dav_dman:
The shred has a 3-5 degree angle up. It will give good top end and good carving with the deep V in it , but to help porpoising you need to buy a few washers and place them between the hull and the ride plate at the rear bolts.
The 99gp800 has a very short pc of junk ride plate that actually causes more porpoising. Trash it. Put ANYTHING else on it. A stock ride plate from a 97-98 1200 will do great. Use a couple washers. I have an RD plate that will work also if you want it. Contact me at dav_dman@yahoo.com . Put your sponsons full down too.
Porpoising gone...along with about 2-3mph top end..but worth it.
The shred has a 3-5 degree angle up. It will give good top end and good carving with the deep V in it , but to help porpoising you need to buy a few washers and place them between the hull and the ride plate at the rear bolts.
The 99gp800 has a very short pc of junk ride plate that actually causes more porpoising. Trash it. Put ANYTHING else on it. A stock ride plate from a 97-98 1200 will do great. Use a couple washers. I have an RD plate that will work also if you want it. Contact me at dav_dman@yahoo.com . Put your sponsons full down too.
Porpoising gone...along with about 2-3mph top end..but worth it.
Comment