If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Was just wondering if the replacement can be done in the hull and if so what are the tricks. I bought a bolt on flywheel lock and have many flywheel pullers.
If you can fit the puller between the gas tank and flywheel you can most likely do it.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Lots of room must remove oil lines to feed manifold and pump cable. A bolt on flywheel lock held the flywheel tight. Must raise front of engine because mounting bosses for motor mounts are casted into Mag cover. Used cherry picker and a strap. A standard 120 degree puller works fine. Thanks
Comment