If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
96 wave venture 1100, how to replace shaft coupler assembly
96 wave venture 1100, how to replace shaft coupler assembly
My original shaft was siezed into the coupler assembly. I cut it out and have used parts on the way. Do i have to move the motor to install the new assembly ?
Re: 96 wave venture 1100, how to replace shaft coupler assembly
Yes the motor must move foward
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Re: 96 wave venture 1100, how to replace shaft coupler assembly
thanks for the reply. How difficult is it to move the motor. looks like the back 2 engine mounts are accesable, does the exhaust have to come off ?
also do i need any new gaskets installing the coupler assembly ? and lastly are there any bearings or other parts you would replace before installing a used coupler and jet pump ? thanks again, Ed
Re: 96 wave venture 1100, how to replace shaft coupler assembly
You may have to remove some exhaust parts to get to the motor mounts up front, Dive into it and see what you may need for gaskets after you get the engine moved up. If you are replacing the coupler shaft then replace the bearing carrier seal assembly too.
SBT Tech Support is here to help with your problems.
We try to answer each question quickly and accurately.
Please do not use Private Messaging for Tech Support, use the forums.
Comment