2004 2005 2006 2007 2008 2009 2010 2011 2012 Speedster 200/ Speedster Wake Custom Exterior Mat Kit
Blacktip Jetsports Mat Kits are a great upgrade to factory traction mats. They provide not only a custom look but superior traction for safety in all types of riding situations from racing to cruising. All mat kits come standard with Blacktip's Jetsports
If you should have a problem, please contact SBT @877.330.0231or firstname.lastname@example.org to identify your issue.
WHAT DOES THIS WARRANTY NOT COVER?
This limited warranty does not cover any damage of the product due to: (a) installation of the product onto any surface; (b) adhesion of the product to a boat deck or to any other surface to which the product is applied; (c) deformation, fading, discoloration or polymer degradation of the product resulting from non-defective materials; (d) exposure of the product to temperatures in excess of 165F which may occur as a result of the amplification of sunlight from reflective surfaces or the passing of sunlight through a refractive medium such as windshields or other structures which shall operate to void this limited warranty; (e) failure to follow the product instructions or to perform preventive maintenance; (f) modifications to the product; (g) unauthorized repair; (h) normal wear and tear; or (i) external causes such as accidents, abuse, or other actions or events beyond our reasonable control.
Option 2)Removal of previously glued down traction mats: Start by peeling a corner of the mat up from the deck. Slowly continue to pull while using a plastic putty knife or scraper to help you release the mat from the glue. Keep working at it until all mats are removed. Once the mats are removed you need to get the left over pieces and the remaining glue residue. We suggest 3M adhesive remover or other suitable brand. This will soften the glue and allow you to scrap and wipe it away.
Clean up:? After all the old mats and glue are removed you will need to clean the surface before installing your new mat set.? Use some rags and solvent for this step. Denatured alcohol, acetone, goof off or goo gone will work here. Change your rag often so as not to just spread the dirt and goo around. After this wash the entire surface with a mild soap and water solution and thoroughly dry ( a day in the sun works best here).
Install: First lay out all the mats in their proper location and check for a good fit. At this point use a pencil and mark a few spots around each mat to use as an alignment guide while sticking them down. Begin by peeling one edge of the first mat you have chosen to install and stick it to the floor making sure to align it with your marks. Once this edge is down you can continue to peel the backing while pressing the mat into place.(DO NOT TRY TO INSTALL THE ENTIRE MAT AT ONCE) After all mats are adhered to the floor of the boat you must apply pressure over the entire surface to activate the PSA (pressure sensitive adhesive). You can do this by standing on all the mats moving around to make sure you apply pressure everywhere, especially the edges.
Care and Maintenance: BlackTip Jetsports Traction Mats are very easy to care for. Rinse them with fresh water while cleaning the boat. Use a mild soap and water solution the same as you would for washing the rest of the boat. For stubborn stains you can use Simple Green, Fantastic, 409 or other similar household cleaner and rinse with water after cleaning.